A Chestnut Glen video is only as good as its sound. A walk under the chestnut trees, fallen leaves underfoot, a few spoken lines over the rustle — most of it is worth keeping, but the first ten seconds of fumbling and the last minute of wind noise are not. Trimming the audio before you cut the video makes the whole edit faster.

Start by opening AudioCutter in your browser. There is nothing to install and nothing to upload — the file stays on your device while you work.

Upload your recording and wait for the waveform to appear. Drag the handles at each end of the waveform to mark the part you want to keep, or click on the waveform to set the start and end points by time. Play the selection back before you commit; a cut that sounds clean on the waveform can still clip a word at the edge, so leave a breath of room at both ends.

If the clip fades in from silence, add a short fade-in so the first note does not hit abruptly. A matching fade-out at the end keeps the clip from stopping dead when the video moves on. Both take seconds and make the result feel finished rather than chopped.

When the selection sounds right, export it. MP3 is the safe choice for sharing and for most video editors; WAV keeps full quality if you plan to mix the clip with music later. Download the file and drop it straight into your video project.

One habit worth keeping: trim the audio first, then cut the video to match. It is much easier to shorten a video clip to fit clean audio than to fix messy audio around a finished video cut.

Disclosure: I'm the developer of AudioCutter (https://audiocutter.me/), a free online audio cutter that runs entirely in your browser. Your files stay on your device — nothing is uploaded.