A forest stream video is mostly about the sound of water — but a raw field recording is usually long, uneven, and full of wind noise at the start. The fix is simple: trim it down to the cleanest stretch and let the stream do the talking. Here is how to do it free, in your browser, with no install and no upload.

Find the cleanest stretch

Open AudioCutter and load your recording. It runs entirely in your browser, so the file never leaves your device. Play through the waveform once and look for the section where the water sounds steady — usually a minute or two in, after the wind gusts and handling noise at the start.

Trim to 30–60 seconds

Drag the selection handles around that steady stretch. For a relaxation or nature video, 30–60 seconds is enough; anything longer and viewers stop noticing the water. Cut the shaky opening and the trailing footsteps, and keep only the part that sounds like a stream.

Fade both ends

Add a short fade-in and a longer fade-out — two seconds in, three seconds out. This matters more for nature audio than for music: a hard cut in running water sounds like a glitch, while a gentle fade sounds like the camera simply drifted away.

Export and loop

Save the clip as MP3, then test it against your footage. If the video is longer than the clip, loop the audio in your editor rather than stretching it — a clean 45-second loop sounds far better than a stretched, warbling one.

That is the whole workflow: find the steady water, trim the noise, fade both ends, export. The free tool at https://audiocutter.me/ handles the trimming — the forest supplies the rest.

Disclosure: I am the developer of AudioCutter (https://audiocutter.me/), a free browser-based audio trimming tool. I wrote this tutorial to show how I use it for my own videos.