"Why are DRAM reads destructive?" shows up in a lot of hardware interviews. The one-line answer is "charge sharing." The answer that survives follow-up questions takes about three minutes, and it explains why tRAS, tWR, and refresh exist at all.
One transistor, one capacitor
An SRAM bit is six transistors holding a latch: it actively keeps its value. A DRAM bit is one transistor and one capacitor (1T1C). It just stores charge. That's why DRAM is so dense and cheap per bit, and also why it's strange to read.
Reading is charge sharing
Before a read, the bitline is precharged to the midpoint, VDD/2. When the wordline rises, the cell's small capacitor connects to the bitline's much larger capacitance, and they settle to one shared voltage:
ΔV = (V_cell − VDD/2) × Cs / (Cs + C_BL)
With illustrative values (VDD = 1.1 V, Cs = 10 fF, C_BL = 40 fF), a stored 1 moves the bitline by 0.55 × 10/50 = 110 mV. A tiny signal.
Now look at the cell. Its capacitor is sitting at the shared voltage, not at a full 1. Reading it mostly erased it.
The sense amplifier reads and restores
A cross-coupled sense amplifier sees that 110 mV, regenerates it with positive feedback to full rail, and, because the access transistor is still on, drives the full value back into the cell. One activate does this for an entire row at once; that row of sense amps is the row buffer.
Why this explains the timing rules
- tRCD: you can't read columns until the sense amps have resolved.
- tRAS: you can't precharge until the restore into the cells is finished.
- tWR: written data must reach the capacitors before the row closes.
- Refresh: capacitors leak anyway, so every row is periodically activated just to restore it.
An interviewer follow-up you should expect: "Why can't a bank have two rows open?" Because a bank has one set of bitlines and sense amps. A second open row would charge-share onto the same bitlines and corrupt both.
Keep going
I wrote a free one-page DDR5 timing cheat sheet that maps each parameter to its physical cause. Download it free. If you want the full treatment, with worked DDR5-4800 examples and 30 interview questions with model answers, there's the DRAM & DDR5 Interview Field Guide.