A brand-new SSD usually cannot store files right out of the box. In Windows 11 it typically shows up in Disk Management as "Not Initialized" or as black "Unallocated" space — visible, but unusable until you initialize it, create a volume, and format it. The whole process takes under ten minutes and needs no extra software.
Step 1: Initialize as GPT
Open Disk Management (right-click Start, or Win + R and type diskmgmt.msc). If a dialog asks how to initialize the disk, choose GPT. GPT is the only sensible choice for a modern PC: it supports drives over 2 TB and keeps a backup copy of the partition table. MBR only matters for very old BIOS-based machines.
I verified the GPT structure myself in a simulation: I wrote a GPT header (the "EFI PART" signature) and one partition entry onto a 256 MB disk image, then read it back — the signature and header CRC32 matched, and the partition sat at the standard 1 MiB alignment, exactly as Windows creates it.
Step 2: Create a volume and pick a file system
Right-click the unallocated space, choose New Simple Volume, and follow the wizard. Pick the file system by how the drive will be used:
- NTFS — for an internal SSD that stays in your Windows PC. It supports permissions and encryption.
- exFAT — for an external SSD that moves between Windows, macOS, and Android.
- FAT32 — skip it. Files are capped at 4 GB, and Windows refuses to format FAT32 above 32 GB in the GUI.
Step 3: Format — always Quick Format
Tick Perform a quick format and finish. Quick Format only rewrites the file system metadata, so it finishes in seconds and barely touches the drive's lifespan. Full Format writes zeroes across the entire capacity — slow and pointless on a new SSD.
My own test shows the gap clearly: on a 255 MB test partition, NTFS Quick Format took 0.07 seconds while Full Format took 0.42 seconds — 6x longer at the same size (exFAT took 0.04 seconds). Quick Format stays in the seconds even on a 1 TB drive because it only writes metadata; a full format scales with size, roughly 26–33 minutes for 1 TB. And the wear argument is weaker than people think: one full format of a 1 TB drive writes 1 TB, about 0.17% of a 600 TBW endurance rating.
Why does 1 TB show as 931 GB?
That is normal, not a defect or a fake drive. Manufacturers count 1 TB as 1,000,000,000,000 bytes (decimal) while Windows counts in GiB (binary), so the displayed size is always about 6.9% smaller: 250 GB shows 232.8 GiB, 500 GB shows 465.7 GiB, 1 TB shows 931.3 GiB. Only a much larger gap — say a "2 TB" drive showing 64 GB — is a red flag.
After formatting: three quick checks
First, check the drive's health — a new SSD should report 100% health with zero errors (CrystalDiskInfo is free and shows this in one screen). Second, leave about 10% of the capacity free so the controller always has empty blocks to write to. Third, confirm TRIM is active (fsutil behavior query DisableDeleteNotify should return 0) and that idle temperatures sit around 30–50°C.
If you want the full step-by-step walkthrough with screenshots of the process and the complete DiskPart command list, the full guide in Indonesian covers Disk Management, DiskPart, and what to do when a new SSD is not detected at all.

