An automated inspection system is any setup of sensors, fixtures and software that judges a part against a spec with no person deciding each case. Search results treat the term as a synonym for machine vision. A leak tester, a coordinate measuring machine (CMM) and a bed of nails on a circuit board are all automated inspection too, and none of them uses a camera.
We wrote the longer version on our blog, Automated Inspection Systems: Three Families, Not One. This post is the part an engineer can run on a real line this week: classify the defects first.
The three families
Each family is defined by what it physically measures.
- Vision: appearance and presence. Surface marks, missing components, print, orientation, colour. Fast and non contact, so it usually runs inline.
- Metrology: geometry to a stated uncertainty. CMMs, laser scanners, air gauges. Slow, usually sampled offline, traceable to a standard.
- Functional test: behaviour. Leak decay, continuity, torque to turn, pressure hold. The result is a number from the part itself.
A defect list you can actually scope from
Pull defects from reject records. Memory is a bad source. Then tag each row:
- defect: scratch on cover type: appearance # vision coverage: every_part - defect: bore out of tolerance type: dimension # metrology coverage: sample - defect: housing leaks type: behaviour # functional test coverage: every_part Coverage is its own column because it moves the budget more than the sensor does. A CMM cannot keep up with a fast line, which is why metrology is usually sampled and vision is usually inline.
Checklist before any supplier demo
- [ ] Every defect tagged appearance, dimension or behaviour
- [ ] Coverage decided per defect, every part or a sample
- [ ] Acceptance test written: recall and precision per defect, on parts from a different shift
- [ ] Presentation priced: fixture, lighting, guarding, controls, changeover
- [ ] A destination agreed for results, since a pass or fail that stays in the machine helps nobody at the next audit
Two families on one line is normal. A pump housing might get inline vision for assembly, a leak test on every unit and a sampled CMM check on the critical bore.
Watch for defects that sit between families. Surface porosity that only matters because it leaks is a behaviour problem in a visual disguise, and the leak test settles it faster.
Dev Station builds the record layer around these stations: result store, operator review screen, gauge integration over Bluetooth or serial. The full breakdown of families, coverage and cost is in the original article.
