You have a list of numbers and your teacher wants the standard deviation. On a TI-84, that is a two-minute job — if you know which of the two numbers on the results screen is yours.
Press STAT, choose 1:Edit, and type your data into list L1. Then press STAT again, go to CALC, choose 1:1-Var Stats, and press ENTER twice. Scroll down: Sx is the sample standard deviation and σx is the population standard deviation.
Entering your data in list L1
- Press STAT and choose 1:Edit.
- If L1 already has old numbers in it, highlight L1 at the top, press CLEAR, then ENTER to empty it.
- Type your first value, press ENTER, and repeat for every data point.
Double-check your entries against the original data — one typo here silently corrupts every statistic that follows.
Running 1-Var Stats
- Press STAT and arrow right to the CALC tab.
- Choose 1:1-Var Stats and press ENTER.
- On the setup screen, make sure List shows L1 and FreqList is blank, then highlight Calculate and press ENTER.
The results screen shows a full summary: x̄ (mean), Σx (sum), Σx² (sum of squares), Sx, σx, and n (count). Sx and σx are near the bottom — arrow down to see them.
Sx vs σx: which one do you need?
This is the question that trips up nearly every student.
- Sx — sample standard deviation. Use it when your data is a sample drawn from a larger population (almost every class problem). It divides by n−1.
- σx — population standard deviation. Use it only when your data is the entire population — every member measured. It divides by n.
When a problem just says "find the standard deviation" without specifying, statistics classes almost always want Sx. If your answer is slightly off from the textbook, check whether you grabbed the wrong one — it is the most common mistake in this whole procedure.
Worked example
Find the standard deviation of the quiz scores: 72, 85, 90, 78, 88.
- STAT → 1:Edit → type the five scores into L1.
- STAT → CALC → 1:1-Var Stats → Calculate.
- Read the screen: x̄ = 82.6, n = 5, Sx ≈ 7.47, σx ≈ 6.68.
Since five quiz scores are a sample of the student's overall performance, the answer is Sx ≈ 7.47.
Finding variance from standard deviation
Variance is simply the square of the standard deviation, and the TI-84 does not list it directly. After running 1-Var Stats, press VARS → 5:Statistics → Sx (or σx), then press the x² key and ENTER. For the quiz-score example above, Sx² ≈ 55.8 is the sample variance.
Mistakes to avoid
- Old data in L1. Leftover numbers silently join your new data. Always clear L1 first.
- Reading σx instead of Sx. They sit right next to each other — slow down and pick the right one.
- Wrong list selected. If you entered data in L2, change the List field on the setup screen to match, or 1-Var Stats will analyze an empty L1 and throw ERR:INVALID DIM.
Try it without a calculator in hand
The full guide has a small calculator built into the page: paste your own data and get the mean, Sx and σx in seconds, with the same TI-84 keystrokes underneath. See the full standard deviation walkthrough with the free calculator.
An independent study guide — not affiliated with or endorsed by Texas Instruments.

